First of all, when we are installing the toilet, we need to have a general view of the sewage pipe, check whether there is any mud and other debris in the pipe, and at the same time, look at the location where the toilet is installed. It is not horizontal. If the floor is not flat, you need to level the ground before you can install it. 2, determine the sewage pipe center
I believe everyone knows that there is a sewage center in the toilet. Before installing the toilet, you must also determine the center of the sewage pipe. We can put the toilet upside down and define the center on the toilet drain. At the same time, draw a cross centerline at the center, and the cross centerline extends to the bottom of the toilet and the feet around it. 3, fixed toilet
Through the above two steps, we can fix the toilet. When fixing the toilet, first align the cross line on the toilet with the floor drain. When installing the toilet horizontally, press the seal tightly, and finally install the screws and decorative cap of the foot.
4, do a good bottom seal
Next, we will install the corresponding sealing ring on the sewage outlet. For example, apply a circle of glass glue (putty) or cement mortar around, and the ratio of cement to sand is 1:3. 5, install the water tank accessories
Finally, the accessories for the water tank are installed. We can put the water for 3 to 5 minutes to flush the pipeline. After ensuring that the water pipe is clean, the angle valve and the connecting hose can be installed, and then the hose is connected to the installed water tank fitting and the water source is connected.
6, commissioning inspection
In order to ensure the installation is successful, the toilet needs to be inspected. It is necessary to check whether the inlet valve and the seal are normal, whether the installation position of the drain valve can be flexible, there is no jamming and leakage, and whether the inlet valve is installed or not. Devices, etc.